Connect the digital output from any Wizard or Puppet board to the input trigger on the RF remote transmitter and you have a programmable RF Remote. When the Wizard or Puppet digital output is activated the RF transmitter sends a signal to an RF receiver, where a remote relay is activated. The RF remote relay is activated ON as long as the RF transmitter sends a signal (LED status indicators built on board) and then turns OFF when no RF signal is received.

Multiple RF Receiver relays can be used to allow switching several devices remotely from a single Wizard / Puppet RF Transmitter signal.
RF Transmitter and Receiver address can be set by on board 8 position DIP switches with 256 different addresses possibilities.
(256 pairs of RF Transmitters and RF Receivers operating simultaneously connected to different devices)

Aprox 50 feet wireless RF transmission range.
434 mHz RF technology
RF Transmitter and RF Receiver operate from 7.5 to 24 Vdc range.
RF Receiver relay rated at 500 mA, but can be connected to SS relays for large loads.

Power supply for RF modules not included
Wizard or Puppet board not inclued.